Design and Experimental Characterization of Electrostatically Assisted Automotive Fuel Injectors

Design and Experimental Characterization of Electrostatically Assisted Automotive Fuel Injectors

4.11 - 1251 ratings - Source



With current automotive fuel injector designs, fuel mass and momentum cannot be independently controlled during engine operation. By introducing electrostatic charge to the fuel as it is injected, a means of altering the injector spray pattern without changing the mass injected is available. A commercially available automotive fuel injector was modified to apply electrostatic charge to the fuel spray. The resulting electrostatically charged sprays were compared to non-charged sprays from the same injector using a Mie scattering technique to image the spray, Fraunhofer diffraction to measure droplet size, and particle image velocimetry to measure droplet velocities. Results showed application of charge results in increased spray penetration during early injection, increased droplet axial velocities, and reduced spray-to-spray variations in droplet size. Measurements of the charge transferred by a spray indicated relatively weak electrostatically induced forces relative to inertial forces, but showed that conductivity enhancers or alcohol blended fuels can substantially increase charge transfer. The effect of charge on the combustion process was investigated by capturing high speed video of charged and non-charged droplets composed of blends of ethanol and isooctane. Substantial changes in droplet morphology depending on the polarity of the charge applied were found. In addition, to test charged sprays in a practical combustion system, an engine test cell was constructed using a spark ignition engine typical of current designs for automotive use. Findings indicate that application of charge to the injector can increase peak cylinder pressure and reduce unburned hydrocarbon emissions a small amount with the trade off of a slight increase in emissions of oxides of nitrogen.Finally, there were instruments which were not connected to either the fuel injection or the NI DAQ. ... Data from the in-cylinder pressure transducer were collected whenever the user pressed the pressure-volume data ... The labview code collected pressure data from a Kistler type 6125B pressure transducer and AVL 3057-AO1 charge amplifier which converted the pressure transducer signal from Picoanbsp;...


Title:Design and Experimental Characterization of Electrostatically Assisted Automotive Fuel Injectors
Author: Eric Karl Anderson
Publisher:ProQuest - 2009
ISBN-13:

You must register with us as either a Registered User before you can Download this Book. You'll be greeted by a simple sign-up page.

Once you have finished the sign-up process, you will be redirected to your download Book page.

How it works:
  • 1. Register a free 1 month Trial Account.
  • 2. Download as many books as you like (Personal use)
  • 3. Cancel the membership at any time if not satisfied.


Click button below to register and download Ebook
Privacy Policy | Contact | DMCA